Home > Forums > Software User Forums > FLOW-3D

Problem with mass source option

Updated Threads

Reply

Search this Thread

October 7, 2015, 03:57	Problem with mass source option	#1
ezgibdk New Member Ezgi Bdk Join Date: Sep 2015 Posts: 3 Rep Power: 10	Hello, I have a problem with mass source option. I cannot check the mass source box, it is inactive. Do you know the reason of this? Thank you for attention Last edited by ezgibdk; October 8, 2015 at 02:39.

January 28, 2016, 13:04		#2
Carmen412 New Member carmen Join Date: Jun 2015 Posts: 3 Rep Power: 10	Enable "Fluid sources" under the Physics tab and check "Activate fluid source model."

Reply

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
sliding mesh problem in CFX	Saima	CFX	46	September 11, 2021 07:38
Simulation of a single bubble with a VOF-method	Suzzn	CFX	21	January 29, 2018 00:58
[foam-extend.org] problem when installing foam-extend-1.6	Thomas pan	OpenFOAM Installation	7	September 9, 2015 21:53
Setting rotating frame of referece.	RPFigueiredo	CFX	3	October 28, 2014 04:59
SparceImage v1.7.x Issue on MAC OS X	rcarmi	OpenFOAM Installation	4	August 14, 2014 06:42

All times are GMT -4. The time now is 22:10.