CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   FLOW-3D (http://www.cfd-online.com/Forums/flow-3d/)
-   -   BC for two mesh blocks (http://www.cfd-online.com/Forums/flow-3d/69210-bc-two-mesh-blocks.html)

Birkov October 15, 2009 09:29

BC for two mesh blocks
 
Hi to all,

I have problem with BC for two mesh blocks. I read this forum and I found that the Flow is capable to solve it(I don't understand the answer) but I can't find how. I tried all BC (I know it's crazy) but I have results only for one mesh block.
Can you give me any suggestion?
Thanks for you time.

L.

Updated: I loaded data to Tecplot and I can see all results (BC - symmetry). But if anyone know how to show all in Flow it will be great. Thank you.

stefmascio October 15, 2009 10:35

hello Birkov,
do you mean that you have done a simulation with 2 mesh blocks and you don't see them in the results? (but with Tecplot yes)
It if it so, then probably you have to select the 2 mesh blocks by pushing the button "Mesh blocks" in the Analyze tab, near the bottom right of the window. By default you display only mesh block 1.

Birkov October 16, 2009 02:36

It was exactly my problem. Thank you very much. I have never seen this miracle button before :).
Thanks a lot.


All times are GMT -4. The time now is 08:21.