Crashing Problem

orionfan · July 6, 2010, 10:58

Hello,

I am creating a tank with a small cylinder in the center as an obstruction. However, any time I try to add any type of geometric subcomponent (STL, my own geometry files, or the built in geometries), the program crashes.

Has this happened to anyone else? and
Does anyone have any advice about how to fix this?

Thanks for your help!

ignatz · July 7, 2010, 10:18

Seems like you ought to have Flow Science support look at your prepin file. Have you contacted them?

orionfan · July 7, 2010, 11:01

Thanks for the reply! I figured out the problem. Apparently, when my simulation was a copy of another, I couldn't add any structures to the mesh. The system would crash. The simulation worked after I created it from scratch and not from a copy.

therockyy · July 9, 2010, 09:18

Have you deleted the component you'd like to import the STL file in? try to import the STL file into another component. I got similar problem several months ago...

Yang

July 6, 2010, 10:58	Crashing Problem	#1
orionfan New Member Join Date: Jun 2010 Posts: 6 Rep Power: 15	Hello, I am creating a tank with a small cylinder in the center as an obstruction. However, any time I try to add any type of geometric subcomponent (STL, my own geometry files, or the built in geometries), the program crashes. Has this happened to anyone else? and Does anyone have any advice about how to fix this? Thanks for your help!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
UDF compiling problem	Wouter	Fluent UDF and Scheme Programming	6	June 6, 2012 04:43
Incoherent problem table in hollow-fiber spinning	Gianni	FLUENT	0	April 5, 2008 10:33
natural convection problem for a CHT problem	Se-Hee	CFX	2	June 10, 2007 06:29
Adiabatic and Rotating wall (Convection problem)	ParodDav	CFX	5	April 29, 2007 19:13
Is this problem well posed?	Thomas P. Abraham	Main CFD Forum	5	September 8, 1999 14:52

July 7, 2010, 10:18		#2
ignatz Member Join Date: Jan 2010 Posts: 39 Rep Power: 16	Seems like you ought to have Flow Science support look at your prepin file. Have you contacted them?

July 7, 2010, 11:01		#3
orionfan New Member Join Date: Jun 2010 Posts: 6 Rep Power: 15	Thanks for the reply! I figured out the problem. Apparently, when my simulation was a copy of another, I couldn't add any structures to the mesh. The system would crash. The simulation worked after I created it from scratch and not from a copy.

July 9, 2010, 09:18		#4
therockyy Member Yang Yue Join Date: Feb 2010 Location: Birmingham, UK Posts: 36 Rep Power: 16	Have you deleted the component you'd like to import the STL file in? try to import the STL file into another component. I got similar problem several months ago... Yang