whats wrong in my simulation?

mostafa_khan · November 26, 2011, 15:34

Hi

i dont undrestand

Whats the problem?

The simulation finished in this time,you will watch in below picture

I gave -9.81 for Z-direction(SI)

What do your idea?
i hope somebody help my

Thanks.

MuxaB · December 12, 2011, 00:46

the output files, hd3msg and hd3out, should have a message at the end explaining the reason for termination, unless the solver crashed. If the latter, then there is no much you can do other than update the software.

samanabasi · December 25, 2011, 15:19

you know that pal

mostafa_khan · December 29, 2011, 13:01

Quote:

Originally Posted by samanabasi

you know that pal

hello my darling

...just this!

November 26, 2011, 15:34	whats wrong in my simulation?	#1
mostafa_khan New Member www.manvatoo.com Join Date: Nov 2011 Posts: 5 Rep Power: 14	Hi i dont undrestand Whats the problem? The simulation finished in this time,you will watch in below picture I gave -9.81 for Z-direction(SI) What do your idea? i hope somebody help my Thanks.

December 25, 2011, 15:19	hi mostafa	#3
samanabasi New Member Saman Join Date: Dec 2011 Posts: 1 Rep Power: 0	you know that pal

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
velocity profile export from a simulation onto another	sudhirlv	STAR-CCM+	1	September 12, 2010 18:57
Simple icoFoam simulation gone wrong	rieuk	OpenFOAM Running, Solving & CFD	3	March 5, 2010 02:24
Replacing mesh while running a simulation	akultane	CFX	1	November 15, 2009 13:46
Underhood simulation	Suresh	Main CFD Forum	0	October 16, 2004 06:29
Fire simulation using FDS from NIST	Jens	Main CFD Forum	1	January 22, 2004 01:53

December 12, 2011, 00:46		#2
MuxaB Senior Member michael barkhudarov Join Date: Mar 2009 Location: Sante Fe, New Mexico, USA Posts: 336 Rep Power: 18	the output files, hd3msg and hd3out, should have a message at the end explaining the reason for termination, unless the solver crashed. If the latter, then there is no much you can do other than update the software.