 |
 |
 |
|
|
|
[Sponsors] | ||||
July 25, 2013, 11:19
|
mass flow outlet
|
#1 |
|
Member
mehdimoradi
Join Date: Jun 2013
Posts: 53
Rep Power: 12  |
Hello everybody
I have a question, Please help me. I am doing simulation a multiphase project (air and 2 solids). I have 3 inlet B.Cs and 2 outlet B.Cs. out lets are as pressure outlet B.Cs. In experiment, solids enter hopper and exit continuously whereas in post processing mass flow out let of solid phases are zero. Why? 
|
|
|
|
|
|
August 8, 2013, 06:55
|
|
#2 |
|
Senior Member
OJ
Join Date: Apr 2012
Location: United Kindom
Posts: 473
Rep Power: 20 |
It really depends on how you have setup the problem. Can you provide the boundary conditions you have used? Also how have you checked that solid phase is zero?
OJ |
|
|
|
|
|
|
August 9, 2013, 13:28
|
|
#3 |
|
Member
mehdimoradi
Join Date: Jun 2013
Posts: 53
Rep Power: 12 |
Hi
Thanks for your response. I have used pressure outlet for two out lets as show in attached picture. In the grain and inert outlet (bottom), we have used a screw conveyor to exit these solid particles only. In other words air do not exit from the bottom outlet. |
|
|
|
|
|
|
August 9, 2013, 13:33
|
|
#4 | |
|
Member
mehdimoradi
Join Date: Jun 2013
Posts: 53
Rep Power: 12 |
Quote:
Thank you. |
||
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mass flow inlet and pressure outlet issue | nikhil | FLUENT | 5 | December 11, 2013 12:30 |
| Mass flow rate at the outlet | tejasvikrishna | FLUENT | 2 | May 25, 2013 02:42 |
| Comparison Mass flow rate at the inlet and outlet??? | vahid.najafi | OpenFOAM Post-Processing | 3 | October 25, 2012 13:36 |
| reversed flow at velocity inlet / mass flow inlet | ib | FLUENT | 1 | March 26, 2007 13:11 |
| Mass flow rate in outlet | Saturn | FLUENT | 1 | October 11, 2004 09:39 |
Linear Mode
