|March 22, 2014, 09:28||
CFD simulation of centrifugal pump cavitation
Join Date: Mar 2014
Posts: 11Rep Power: 3
I am starting to work on a thesis which requires me to run CFD simulation of centrifugal pump that has cavitation issues at the inlet or eye of the impeller. I must use Ansys for this simulation.
As I am new in this field, I need to know:
1- Whether I need the geometry of only the impeller or should I use the complete impeller and volute casing assembly?
2- Is it possible to simulate this problem with 2 phase flow i.e nucleate boiling?
|Thread||Thread Starter||Forum||Replies||Last Post|
|Request for CFD consulting: centrifugal pump simulation||Verdi||CFD Freelancers||13||April 29, 2015 12:03|
|Centrifugal Pump Cavitation problem or not.||ismael.s||CFX||13||February 27, 2012 09:00|
|CFD analysis of centrifugal pump||saurabh9978||FLUENT||1||April 6, 2010 05:40|
|pump simulation||chandra||FLUENT||1||March 18, 2003 15:51|
|Cavitation Simulation by CFD||Liu, L.||Main CFD Forum||7||November 1, 2000 22:26|