Operating density (UDF?) multiphase problem

GM_XIII · April 22, 2014, 07:04

Hi all,

I am trying to model a multiphase flow clearly dominated by floatability and it clearly depends on the operating density specified. I've read some say is better to set it to the density of the lightest phase but that doesn't seem accurate to my problem. So i would like to model it with a UDF, is this possible? I think no.

note: i am suing the mixture model

Thanks in advance for your opinion

GM_XIII · July 10, 2014, 07:11

It's been some time but if someone has similar issues. The best for me was setting the reference density to 0. When you activate gravity, your pressure boundary conditions are P(BC)=Ptotal-Preference-rho0(reference density)*g*z(of the face centroid). So in order to define a constant gauge pressure the best practice is to set reference density to 0. Fluent does the above described becouse of roundoff errors, take it in count.

Regards

April 22, 2014, 07:04	Operating density (UDF?) multiphase problem	#1
GM_XIII Member David Join Date: Aug 2012 Posts: 48 Rep Power: 13	Hi all, I am trying to model a multiphase flow clearly dominated by floatability and it clearly depends on the operating density specified. I've read some say is better to set it to the density of the lightest phase but that doesn't seem accurate to my problem. So i would like to model it with a UDF, is this possible? I think no. note: i am suing the mixture model Thanks in advance for your opinion Last edited by GM_XIII; April 23, 2014 at 02:06.

July 10, 2014, 07:11		#2
GM_XIII Member David Join Date: Aug 2012 Posts: 48 Rep Power: 13	It's been some time but if someone has similar issues. The best for me was setting the reference density to 0. When you activate gravity, your pressure boundary conditions are P(BC)=Ptotal-Preference-rho0(reference density)gz(of the face centroid). So in order to define a constant gauge pressure the best practice is to set reference density to 0. Fluent does the above described becouse of roundoff errors, take it in count. Regards ghost82, Debanand, thermal energy and 2 others like this.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
UDF for coal combustion in multiphase flow	niisha24	Fluent UDF and Scheme Programming	13	September 19, 2022 04:01
A problem about 'printf' and 'Message' in UDF.	LICH	Fluent UDF and Scheme Programming	2	May 2, 2013 02:45
Problem with rhoSimpleFoam : exploding enthalpy and density at the walls	david39	OpenFOAM Running, Solving & CFD	6	January 18, 2011 11:49
Problem with my udf	july	Fluent UDF and Scheme Programming	3	June 20, 2010 06:56
the problem of C_R_G in UDF	may	FLUENT	0	August 19, 2007 21:07