|June 2, 2015, 10:13||
issue in mass flow rate graph
Join Date: Oct 2013
Location: Somewhere on Earth
Posts: 285Rep Power: 5
Here I have a strange issue,
I' modeling an axisymmetric 2 phases flow in a tube,
at the end of simulation, I plot the mass flow rate graph some section across the radius, but there is an issue,
As it's clear in the pictures, mass flow rate for each phase near the axis is zero!
I guess it's logical to mass flow be Max. at the axis, so I think it's irrational!
what do you think!? you think these graphs wrong too!!?
Last edited by amin.z; June 2, 2015 at 13:04.
|Thread||Thread Starter||Forum||Replies||Last Post|
|issue in mass flow rate graph||amin.z||FLUENT||0||June 2, 2015 10:11|
|Pressure Outlet Targeted Mass Flow Rate||LuckyTran||FLUENT||0||March 9, 2015 01:26|
|Mass flow rate boundary condition for continuity equation for oscillating flow||p07ip705||Main CFD Forum||0||February 28, 2013 02:33|
|mass flow in is not equal to mass flow out||saii||CFX||2||September 18, 2009 08:07|
|Target Mass Flow Rate||Nitin||FLUENT||6||March 12, 2004 06:39|