CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   Fluent UDF and Scheme Programming (http://www.cfd-online.com/Forums/fluent-udf/)
-   -   Compiling UDF within Workbench (http://www.cfd-online.com/Forums/fluent-udf/113447-compiling-udf-within-workbench.html)

NPat February 19, 2013 21:44

Compiling UDF within Workbench
 
Dear friends,

I'm able to compile a UDF from FLUENT launcher, but it cannot be done when I start FLUENT from Workbench. Anyone has some tip on how to do that? :confused:

Regards,
Natan

vasava March 13, 2013 07:25

Are you sure that your UDF is in same place at your case files.

Put your UDF in CaseFolder>dp0>FFF>Fluent and then try to compile.

michujo April 15, 2013 12:42

Hi, I am facing the exact same problem.

I was able to compile the UDF and run the case launching Fluent without Workbench, but It is not working within Workbench.

Did you managed to solve the problem? If yes, could you please explain how you did it?

Many thanks in advance.

Regards,
Michujo.

EDIT: Yes, the UDF source files are in the right folder. It worked fine with Fluent (outside Workbench).

vasava April 24, 2013 03:36

Do compiling and interpreting both work outside workbench? If the compiling is not working then you must correct the visual basic set-up for fluent.

gerardosrez December 11, 2014 09:55

Where you able to solve your issue with workbench?? I have the same question because you have to start workbench from SDK so what would be the working directory??? the one with the workbench files or the one with the fluent flies (udf lib etc)

Best regards...

ho3ein.agl December 17, 2014 14:45

good news :)

step1: uninstall visual studio express 2013 or 2010 or c++
step2: install Microsoft Visual Studio 2010 Ultimate v10.0 (or pro)

everything is fine :)
even dont need to start workbench or fluent from SDK


All times are GMT -4. The time now is 19:02.