|April 1, 2013, 23:18||
surface reaction UDF
Join Date: May 2012
Posts: 6Rep Power: 6
I compiled UDF for surface reaction and I selected it in the User-Dened Function Hooks panel; however, I donot see any reaction rate that I compiled.
How can I use the compiled surface reaction?
Because it is surface reaction, I think I should see this reaction from the boundary condition, but I just see the reaction from the species tap. It connects the surface reaction mechanism, which is not the reaction that I compiled.
In addition, what is the NUM_SPECS?
for example, I saw it from the UDF manual
/* Species numbers. Must match order in Fluent panel */
#define HF 0
#define WF6 1
#define H2O 2
#define NUM_SPECS 3
I saw many people use this NUM_SPECS in surface reaction UDF. I can not find this material from the fluid list.
|June 16, 2013, 03:23||
the same problem
Join Date: Apr 2013
Posts: 40Rep Power: 5
Hi taekyu8,my problem is similar with the first part of your problem,inspite of compiling and hooking my suface reaction rate udf,I can't see it in the material panel,
Is your problem has been solved?
I hope your sucess reply.thanks in advanc.
Last edited by firstname.lastname@example.org; June 16, 2013 at 03:24. Reason: making mistake
|Thread||Thread Starter||Forum||Replies||Last Post|
|Wall surface reaction, definition issue||GBNB||Fluent UDF and Scheme Programming||2||February 23, 2013 03:09|
|question about udf for "particle surface reaction rate"||lili||Fluent UDF and Scheme Programming||0||January 9, 2013 04:37|
|[ICEM] Problems with coedge curves and surfaces||tommymoose||ANSYS Meshing & Geometry||0||August 5, 2011 16:02|
|udf for partical surface reaction||blaid||FLUENT||0||April 25, 2011 07:24|
|chemical reaction - decompostition||La S. Hyuck||CFX||1||May 23, 2001 00:07|