|May 22, 2014, 03:40||
changing buondary conditions during the time
Join Date: May 2014
Posts: 1Rep Power: 0
I have 2 boundary conditions in my problem and want to replace them with each other during the time.
For example, changing "velocity inlet" B.C. to "Pressure outlet" after 5 minutes and then back to the first case.
This procedure continues periodically to end of the running program.
How can i do this?
Thank you in advance.
|Thread||Thread Starter||Forum||Replies||Last Post|
|simpleFoam error - "Floating point exception"||mbcx4jc2||OpenFOAM Running, Solving & CFD||10||April 21, 2015 19:45|
|mixerVesselAMI2D's mass is not balancing||sharonyue||OpenFOAM Running, Solving & CFD||6||June 10, 2013 09:34|
|Upgraded from Karmic Koala 9.10 to Lucid Lynx10.04.3||bookie56||OpenFOAM Installation||8||August 13, 2011 04:03|
|Orifice Plate with a fully developed flow - Problems with convergence||jonmec||OpenFOAM Running, Solving & CFD||3||July 28, 2011 05:24|
|calculation diverge after continue to run||zhajingjing||OpenFOAM||0||April 28, 2010 04:35|