 |
 |
 |
|
|
|
[Sponsors] | ||||
desired velocity profile from fan boundary condition |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 24, 2015, 15:27
|
desired velocity profile from fan boundary condition
|
#1 |
|
New Member
Join Date: May 2012
Posts: 7
Rep Power: 13  |
Hello everyone!
i am trying to develop a desired velocity profile from UDF using fan BC, but unfortunately i am not getting it. I am attaching a pic which explains the problem as that the edge in the mesh is the fan. A flow will start from the velocity inlet (left) and will pass through and over the fan BC edge where i have hooked a UDF for profile specification of pressure-jump. But even doing this i am not getting the desired profile. Kindly Help urgently! Regards and Thank you! |
|
|
|
|
|
March 5, 2015, 21:59
|
|
#2 |
|
Senior Member
Join Date: Mar 2015
Posts: 892
Rep Power: 18 |
Could you provide your UDF and the equation that describes the fan boundary condition?
|
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Difficulty in calculating angular velocity of Savonius turbine simulation | alfaruk | CFX | 14 | March 17, 2017 06:08 |
| Radiation interface | hinca | CFX | 15 | January 26, 2014 17:11 |
| CFX fails to calculate a diffuser pipe flow | shenying0710 | CFX | 7 | March 26, 2013 04:13 |
| [Pointwise] cannot set "fan" boundary condition to 2D Ducted fan model | brksnn | Pointwise & Gridgen | 1 | January 11, 2013 09:05 |
| Velocity inlet boundary condition for porous medium | Chander | CFX | 3 | March 11, 2012 21:18 |
Linear Mode
