 |
 |
 |
|
|
|
[Sponsors] | ||||
September 20, 2015, 15:00
|
Define_geom macro
|
#1 |
|
New Member
mohsen
Join Date: Jun 2015
Posts: 25
Rep Power: 10  |
Hi
I want to simulate a bit while drilling a vertical hole by means of dynamic mesh method. So I need to use DEFINE_GEOM MACRO to describe penetration of bit as a cylinder that is growing its height. So question is: How could I define cylinder geometry in Cartesian coordination in a DEFINE_GEOM MACRO? BEST REGARDS |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Macro within a Macro | beyonder1 | Tecplot | 1 | September 4, 2015 18:33 |
| How to use the thread_storage macro? | lxlxlxt | FLUENT | 0 | February 10, 2014 21:53 |
| StarCCM+ Command line options and Macro execution | isidp | STAR-CCM+ | 8 | January 29, 2013 05:00 |
| Macro Trouble -Winows Explorer Crashes with Macro | Martin Castillo | FLUENT | 1 | July 25, 2007 04:18 |
| Macro problem | cfddummy | Siemens | 1 | April 9, 2007 12:37 |
Linear Mode
