Error: chip-exec: function "UDF" not found.

bruzzelbirne · January 13, 2010, 05:01

Hi,

i am trying to simulate mass transfer through a dense membrane but i get an error:
Error: chip-exec: function "UDF" not found.
This error occurs everytime i initialize the solver after i removed the "libudf", changed the udf, compiled it and loaded it again.
This error even occurs when i copy the fluent data from one directory to another and initialize the solver.
Can anyone help me please?

Thanks

novice · March 1, 2010, 08:34

Hi
After removing the UDF u probably have to save the cas and data..and then open the case again...
hope itworks
regards

Malue · February 10, 2017, 04:11

Hello

I have the same problem. And save the .cas and .dat file with the new loaded UDF does Not work...

any other suggestion !

January 13, 2010, 05:01	Error: chip-exec: function "UDF" not found.	#1
bruzzelbirne New Member Join Date: Jan 2010 Posts: 1 Rep Power: 0	Hi, i am trying to simulate mass transfer through a dense membrane but i get an error: Error: chip-exec: function "UDF" not found. This error occurs everytime i initialize the solver after i removed the "libudf", changed the udf, compiled it and loaded it again. This error even occurs when i copy the fluent data from one directory to another and initialize the solver. Can anyone help me please? Thanks

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Compile problem	ivanyao	OpenFOAM Running, Solving & CFD	1	October 12, 2012 09:31
Problems in compiling paraview in Suse 10.3 platform	chiven	OpenFOAM Installation	3	December 1, 2009 07:21
Regarding FoamX running Kindly help out	hariya03	OpenFOAM Pre-Processing	0	April 18, 2008 04:26
Problem with rhoSimpleFoam	matteo_gautero	OpenFOAM Running, Solving & CFD	0	February 28, 2008 06:51
[blockMesh] Axisymmetrical mesh	Rasmus Gjesing (Gjesing)	OpenFOAM Meshing & Mesh Conversion	10	April 2, 2007 14:00

March 1, 2010, 08:34		#2
novice Member novice Join Date: Nov 2009 Posts: 33 Rep Power: 16	Hi After removing the UDF u probably have to save the cas and data..and then open the case again... hope itworks regards

February 10, 2017, 04:11		#3
Malue New Member Markus Lücking Join Date: Jan 2017 Posts: 10 Rep Power: 9	Hello I have the same problem. And save the .cas and .dat file with the new loaded UDF does Not work... any other suggestion !