Multiplying heat transfer coefficient by a factor -- CFD Online Discussion Forums

April 20, 2021, 08:48	Multiplying heat transfer coefficient by a factor	#1
antonio.c New Member Antonio Join Date: Jun 2017 Posts: 9 Rep Power: 8	Hello, I am working on a Fluent model to simulate conjugated heat transfer (turbulent flow-soid). In order to match experimental measurement I need to scale the heat transfer coefficient by a factor. I think I should use a UDF, but I would like to avoid to redefine the calculations for the heat transfer coefficient, I would just like to let Fluent calculate the heat transfer coefficient as it is defined by the model, then multiply this by a factor in order to calculate the heat flux. Anyone know if this is possible?

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Setting the height of the stream in the free channel	kevinmccartin	CFX	12	October 13, 2022 21:43
Heat transfer coefficient - what is waht	Stan	FLUENT	28	December 29, 2021 16:29
How To Calculate Average Heat Transfer Coefficient in CFD-Post?	Shomaz ul Haq	CFX	16	November 24, 2019 18:57
Difficulty In Setting Boundary Conditions	Moinul Haque	CFX	4	November 25, 2014 17:30
Convective / Conductive Heat Transfer in Hypersonic flows	enigma	Main CFD Forum	2	November 1, 2009 22:53

All times are GMT -4. The time now is 05:14.