Simple UDFhelp Required

Shrinand · June 22, 2010, 03:10

According to the equation displayed below, I need to acquire temperature values (Tc) for calculating Q_loss.

Tc the (modeled) temperature inside the combustor, T∞ ambient temperature. Then Resistance is calculated as follows-
(2)

(3)

Pls tell me only how to acquire value of Tc.

coglione · June 22, 2010, 08:34

If Tc means the temperature of a given cell C_T(c,t) is what you need.

cheers

Shrinand · June 22, 2010, 09:00

Thanks,, it works.. only i got many parse errors with capitalisation. All corrected. Thank u!!

Shrinand · June 23, 2010, 02:07

Sorry for double post.. I have another doubt.i need to incorporate this line in the UDF. It is about removing the heat flux from a 2D plane, such that 3D results are obtianed.

Pls just tell me How to Subs for Heat flux.. Q = Q .+ (-2*(temp-300)/R);
just as Temperature is given by temp = C_T(c,t);

Pls reply ..

June 22, 2010, 03:10	Simple UDFhelp Required	#1
Shrinand New Member Shrinand Iyer Join Date: Jun 2010 Posts: 5 Rep Power: 15	According to the equation displayed below, I need to acquire temperature values (Tc) for calculating Q_loss. Tc the (modeled) temperature inside the combustor, T∞ ambient temperature. Then Resistance is calculated as follows- (2) (3) Pls tell me only how to acquire value of Tc.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
paraview installation woes	vex	OpenFOAM Installation	15	January 30, 2011 07:11
[OpenFOAM] Problem with paraFoam on a linux-64 bit	bunni	ParaView	4	April 14, 2010 20:55
Version 15 on Mac OS X	gschaider	OpenFOAM Installation	113	December 2, 2009 10:23
paraFoam reader for OpenFOAM 1.6	smart	OpenFOAM Installation	13	November 16, 2009 21:41
SIMPLE code - basics required!	Glynn	Main CFD Forum	7	May 17, 2004 07:53

June 22, 2010, 08:34		#2
coglione Senior Member Max Join Date: Mar 2009 Posts: 133 Rep Power: 17	If Tc means the temperature of a given cell C_T(c,t) is what you need. cheers

June 22, 2010, 09:00		#3
Shrinand New Member Shrinand Iyer Join Date: Jun 2010 Posts: 5 Rep Power: 15	Thanks,, it works.. only i got many parse errors with capitalisation. All corrected. Thank u!!

June 23, 2010, 02:07		#4
Shrinand New Member Shrinand Iyer Join Date: Jun 2010 Posts: 5 Rep Power: 15	Sorry for double post.. I have another doubt.i need to incorporate this line in the UDF. It is about removing the heat flux from a 2D plane, such that 3D results are obtianed. Pls just tell me How to Subs for Heat flux.. Q = Q .+ (-2*(temp-300)/R); just as Temperature is given by temp = C_T(c,t); Pls reply ..