|August 11, 2010, 11:57||
tagging of single nodes.
Join Date: Aug 2010
Posts: 20Rep Power: 5
at the moment i am working on an fsi in fluent.
finally it was not so hard to programm an fsi for struktural simulation. (for only one part).
but now i need to split my part... (for different material id's)
my solution was to compare (at the first fsi loop) the external grid koordinates with the internal node koordinates of fluent.
so fluent makes a loop over all shell node and if the koordinates match it stores the external nodenumber into NODE_MARK(v).
after that i can work with nodemark and easily write the needed informations for the external program into a file.
but after the first fsi loop some of the NODE_MARK(v) values have changed!
is there a way to get the internal nodenumber of fluent?
then i could make a table between the fluentnodenumbers and the external nodenumbers.
i'm not shure but is NODE_MARK(v) the global nodenumber of fluent?
sorry for my bad english
|Thread||Thread Starter||Forum||Replies||Last Post|
|Dual Nodes is Slower Than Single Node (Reposting)||Mrxlazuardin||Hardware||1||May 26, 2010 11:25|
|Dual Nodes is Slower Than Single Node||Mrxlazuardin||FLUENT||0||May 21, 2010 02:48|
|Scale-Up Study in Parallel Processing with OpenFoam||sahm||OpenFOAM||10||April 26, 2010 18:37|
|meshing F1 front wing||Steve||FLUENT||0||April 17, 2003 13:37|
|CFX4.3 -build analysis form||Chie Min||CFX||5||July 13, 2001 00:19|