|February 22, 2011, 03:51||
udf for transient mass flow rate inlet
Join Date: Feb 2011
Posts: 2Rep Power: 0
I am trying to figure out how to write a udf for applying a transient mass flow rate at the inlet. In my case study the mass flow rate varies with time from 0 to 40L/min and then comes down to zero in one cycle that ranges from 0 to 4 sec.
If anybody have a ready made udf, i wud be grateful if u could plz post it in this link or pass on through my email id.
I admit i have a bad programming knowledge but since it is bit urgent, i have to seek ur opinion and help without having to take the pain to learn it myself.
Plz do help
|Thread||Thread Starter||Forum||Replies||Last Post|
|UDF for inlet mass flow rate||rahulsuresh89||Fluent UDF and Scheme Programming||1||October 16, 2010 18:06|
|2D axisymmetric mass flow rate for the plain orifice atomizer||jwillie2000||FLUENT||2||September 17, 2010 06:43|
|mass flow rate inlet udf||alikami||Fluent UDF and Scheme Programming||3||June 4, 2010 14:47|
|Mass Flow Inlet||Pravir Kumar Rai||FLUENT||0||February 19, 2003 15:03|
|Mass Flow Inlet||Pravir Kumar Rai||FLUENT||0||February 17, 2003 20:23|