 |
 |
 |
|
|
|
[Sponsors] | ||||
September 7, 2011, 19:16
|
Volume Fraction at boundary
|
#1 |
|
Member
Pranab N Jha
Join Date: Nov 2009
Location: Houston, TX
Posts: 86
Rep Power: 16  |
Hello,
I want to change the volume fraction at the boundary for incoming fluid from 0 to 1 (that is changing the fluid entering at the boundary) using a UDF. Can somebody tell me how to do this? http://my.fit.edu/itresources/manual...df/node271.htm This link tells me that I can use the DEFINE_PROFILE macro to change the volume fraction at the boundary. But the only macro available for this is the C_VOF which is applied on a cell thread and not a face thread. Any suggestions? |
|
|
|
|
|
September 11, 2011, 09:07
|
|
#2 |
|
Member
Pranab N Jha
Join Date: Nov 2009
Location: Houston, TX
Posts: 86
Rep Power: 16 |
Silly question. Got the answer. Nevermind folks
|
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Weighted average volume fraction | Yasser | FLUENT | 5 | April 11, 2015 08:25 |
| Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |
| [blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |
| How to apply negtive pressure to outlet | bioman66 | CFX | 5 | June 3, 2006 01:40 |
| Volume Fraction | cheong | FLUENT | 1 | November 28, 2001 04:06 |
Linear Mode
