|November 18, 2011, 04:04||
What is the cuase of dynamic mesh no working?
Join Date: Feb 2011
Posts: 9Rep Power: 7
I need to make the wall where is deformed by pressure, then I write the UDF code DEFINE_GEOM(deform, domain, dt, position) to define the boundary moving of wall. Everything look fine, but the meshes in side close to boundary were not moving properly, only the boundary is moved. So I quite doubt with this.
I used dynamic mesh-- layer (height base) and mesh element type is Quad
|Thread||Thread Starter||Forum||Replies||Last Post|
|Regarding Negative volume detected in Dynamic mesh||Vinay Morabad||FLUENT||10||December 16, 2015 01:31|
|Dynamic Mesh on Pintle type injector.||herntan||FLUENT||15||January 4, 2012 04:31|
|Dynamic Mesh Diffusivity Problem||dancfd||OpenFOAM Native Meshers: blockMesh||0||August 29, 2010 11:50|
|Dynamic mesh - structured mesh||mrestrepo30||FLUENT||0||June 3, 2009 15:40|
|dynamic mesh not working||studentwhoneedshelp||FLUENT||4||July 24, 2008 03:31|