|February 4, 2012, 01:44||
UDF for linear temperature profile on horizontal parallel surfaces.
Join Date: Feb 2012
Posts: 18Rep Power: 3
I am analyzing the thermoacoustic heat engine.For that, I need to give linear temperature profile on parallel horizontal surfaces whose length are 10mm and thickness of stack plate is 0.5 mm and gap between plates are also 0.5mm. I have gone through the UDF manual of Fluent and found that I need to use DEFINE_PROFILE and F_PROFILE but not able to write UDF.
I have given schematic sketch below.(It is sketch not according to the scale.)
As shown in the above fig.,origin is shown as (0,0), there are 12 parallel plates of length 10 mm having thickness 0.5mm and gap between them is also 0.5mm and whose hot ends are at 587 K and cold ends are at 300 K and horizontal surfaces are required to give linear temperature profile.
Equation for that is: T= ((- 28700 * x)+ 1448) Kelvin
Anyone can help me to write UDF.
|February 11, 2012, 09:45||
Join Date: Jun 2011
Posts: 105Rep Power: 4
See the post below:
You will need to define the UDF under define_profile macro.
|udf for temp. profile|
|Thread||Thread Starter||Forum||Replies||Last Post|
|UDF error - parabolic velocity profile - 3D turbine||Zaqie||Fluent UDF and Scheme Programming||7||September 23, 2012 04:23|
|Define profile inlet_temperature in UDF||mohammadkm||Fluent UDF and Scheme Programming||16||March 14, 2012 13:28|
|UDF velocity and temperature||Raj||FLUENT||3||February 1, 2009 19:29|
|UDF: temperature profile||dolores||FLUENT||5||March 30, 2004 05:53|
|temperature profile on boundary||sivakumar||FLUENT||5||November 24, 2002 01:58|