|April 23, 2012, 17:21||
Ansys Workbench Exported design points
Kevin Van Looveren
Join Date: Nov 2011
Posts: 11Rep Power: 3
I'm studying the influence of some parameters using the workbench design parameters.
I've exported my design points to be able to look at other parameters should they pop up without having to rerun my 10+ hr simulations. (individual measuring of the parameter would be even faster)
I however can only see the fluent output parameters in the individual design points. Is there a way I can let them be visible on the main project ?
On a different note, working without the exported option keeps failing:
My periodic boundary conditions keep bugging and resetting. Fluent fails to automaticly remake the boundaries periodic and gives incompatible mesh errors. (In the exported case I just have to individually open fluent and make them periodic again). Is there something I can do about this ?
(Exported cases aren't just running by themselves, so this would save some time for other studies)
|Thread||Thread Starter||Forum||Replies||Last Post|
|error in opening fluent in ansys workbench||tmeysam92||ANSYS||3||March 12, 2013 07:10|
|importing mesh from Gambit and other software to ansys workbench||mortazavi||CFX||13||May 30, 2012 10:00|
|How can I start the ANSYS 12 workbench in LINUX||Ardisia||ANSYS||3||September 7, 2010 00:19|
|BlockMeshmergePatchPairs||hjasak||OpenFOAM Native Meshers: blockMesh||11||August 15, 2008 07:36|
|Macro command combatibility ANSYS workbench||Tassos||CFX||2||February 29, 2008 10:02|