 |
 |
 |
|
|
|
[Sponsors] | ||||
May 2, 2012, 08:23
|
Help with this iterate problem
|
#1 |
|
New Member
zhou minjian
Join Date: May 2012
Posts: 1
Rep Power: 0  |
Good evening everyone.
What I am trying to simulate is a gear pump, but every time I iterate ,it comes the problem of 'Error: Update-Dynamic-Mesh failed. Negative cell volume detected.' I have examined the grids in the gambit and checked it before iterating.But the problem always comes out after about 30 steps when I set the time step size of 0.0001s. Some authers suggest me to decrease the time step size. But if I decrease the time step size, the error comes out as well. I nearly tried everything that I can do, but still can't solve it. Can you help me and give some suggestions? THANKS. |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem with interFoam; Wave/wiggle alpha1 behavior | JonW | OpenFOAM | 10 | February 4, 2023 07:27 |
| UDF compiling problem | Wouter | Fluent UDF and Scheme Programming | 6 | June 6, 2012 04:43 |
| natural convection problem for a CHT problem | Se-Hee | CFX | 2 | June 10, 2007 06:29 |
| Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |
| Is this problem well posed? | Thomas P. Abraham | Main CFD Forum | 5 | September 8, 1999 14:52 |
Linear Mode
