How to create the rotating reference frame of a MRF problem in DesignModeler wrt to t

Zev Xavier · May 8, 2012, 01:01

Hi

I am new to Fluent and am wanting to apply a Multiple Reference Frame model to my simple centrifugal pump geometry to analyse the flow behaviour within the pump. I am using an assembly of two components the first being a solid impeller and the second being the geometry of the wetted surface area within the pump housing and volute, please images below

. I used SolidWorks for the generation of both components. My currect concern is how to create the multiple zones where two fluid zones are connected via an interface boundary so as to later define the rotating frame in Fluent. I am not sure how to created this in Design Modeler.

Although I am sure this step is rather simple for those already understanding how to create these multiple fluid zone boundary interfaces, It has proved rather challanging for me even after devoting a significant amout of time to understanding this step.

I appreciate any assistance in helping me understand this process.
__
Zev

Impeller:

Fluid Geometry

Far · May 11, 2012, 03:59

There is no need to do it in DM. Treat both separately in DM as well in ANSYS meshing. You should create the interfaces for MRF in Fluent/CFX.

May 8, 2012, 01:01	How to create the rotating reference frame of a MRF problem in DesignModeler wrt to t	#1
Zev Xavier New Member Zev Xavier Join Date: May 2012 Location: Australia Posts: 10 Rep Power: 13	Hi I am new to Fluent and am wanting to apply a Multiple Reference Frame model to my simple centrifugal pump geometry to analyse the flow behaviour within the pump. I am using an assembly of two components the first being a solid impeller and the second being the geometry of the wetted surface area within the pump housing and volute, please images below. I used SolidWorks for the generation of both components. My currect concern is how to create the multiple zones where two fluid zones are connected via an interface boundary so as to later define the rotating frame in Fluent. I am not sure how to created this in Design Modeler. Although I am sure this step is rather simple for those already understanding how to create these multiple fluid zone boundary interfaces, It has proved rather challanging for me even after devoting a significant amout of time to understanding this step. I appreciate any assistance in helping me understand this process. __ Zev Impeller: Fluid Geometry

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Second Derivative Zero - Boundary Condition	fu-ki-pa	OpenFOAM	11	March 27, 2021 04:28
UDF for defining a body force in Singel ROtating Reference Frame	teymourj	Fluent UDF and Scheme Programming	9	August 18, 2016 15:33
Boundary conditions for rotating reference frame	Borna	OpenFOAM	1	August 24, 2011 10:25
[blockMesh] Include list of points	Hikachu	OpenFOAM Meshing & Mesh Conversion	0	June 20, 2011 09:03
Rotating Reference Frame	Ketan	FLUENT	0	May 17, 2007 13:13

May 11, 2012, 03:59		#2
Far Super Moderator Sijal Join Date: Mar 2009 Location: Islamabad Posts: 4,553 Blog Entries: 6 Rep Power: 54	There is no need to do it in DM. Treat both separately in DM as well in ANSYS meshing. You should create the interfaces for MRF in Fluent/CFX.