|
[Sponsors] |
May 14, 2012, 14:40 |
important question regarding residual
|
#1 |
Senior Member
hamid
Join Date: Nov 2010
Posts: 185
Rep Power: 15 |
Dear All
I would like to ask, how much a residual might be, i know that it totally depends, but I want to decide about my simulation, on the other hand seems it is hard to get residual less than 10^-3, i am simulating a pipe with a branch, all the b.c. are static pressure, it is steady state simulation but in next stage i simulate a two phase flow with unsteady regime, reynolds around 1200, laminar flow, again i would like to know whats is the rule to define approperiate residual, either of my case and in general.. thank you so much Hamid |
|
May 15, 2012, 10:16 |
|
#2 |
Senior Member
hamid
Join Date: Nov 2010
Posts: 185
Rep Power: 15 |
this question is still very important for me
thanks |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
SimpleFoam k and epsilon bounded | nedved | OpenFOAM Running, Solving & CFD | 16 | March 4, 2017 09:30 |
Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 07:20 |
Interfoam blows on parallel run | danvica | OpenFOAM Running, Solving & CFD | 16 | December 22, 2012 03:09 |
Error log | vw.cfd | OpenFOAM | 6 | August 7, 2009 06:44 |
Negative value of k causing simulation to stop | velan | OpenFOAM Running, Solving & CFD | 1 | October 17, 2008 06:36 |