 |
 |
 |
|
|
|
[Sponsors] | ||||
May 29, 2012, 22:54
|
Eulerian wall film model
|
#1 |
|
New Member
Lei Yu
Join Date: May 2012
Posts: 1
Rep Power: 0  |
Hello All,
I am simulating aftertreatment SCR process. In the modeling I used eulerian wall film model and activatee the DPM collection. But in the calculation Fluent doesn't collect particls in fact. At last I found I must set how often the DPM phase is calculated for the film. But unluckily I can't let DPM contol available in the tab of solution method and control. Have you met the silimar problem? If you have, could you help me to solve this problem. Thank you very much! Best regards， Lei Yu |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Near wall treatment in k-omega SST | Arnoldinho | OpenFOAM Running, Solving & CFD | 38 | March 8, 2017 13:48 |
| Superlinear speedup in OpenFOAM 13 | msrinath80 | OpenFOAM Running, Solving & CFD | 18 | March 3, 2015 05:36 |
| Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |
| Erosion model and Eulerian Model | leonozx | FLUENT | 0 | April 7, 2011 05:45 |
| Mixture and Eulerian Model | Hassid S. | FLUENT | 1 | August 9, 2007 07:24 |
Linear Mode
