CFD Online Discussion Forums

CFD Online Discussion Forums (
-   FLUENT (
-   -   Fire Simulation using fluent (

Vignesh V July 11, 2012 03:55

Fire Simulation using fluent

I'm trying to model a fire inside a room of 5*5*5 (m) with a fire source of 0.1*0.1*0.1 m bottom center of the room. how do I simulate the fire to find the heat distribution in the domain. what should be the boundary conditions that I should define. please let me know the procedure.

Thanks in advance

flotus1 July 11, 2012 04:03

The easiest solution would be to model the fire as an energy source.

Vignesh V July 11, 2012 08:09

Fire Simulation using fluent

Can you elaborate the procedure.

flotus1 July 11, 2012 10:08

Am I right assuming that you have very little experience with CFD in general and with Fluent?

In this case, I strongly recommend you do some of the basic tutorials first.
I will not explain the whole setup procedure since it would simply take too long and never be complete.

The third tutorial Chapter 3: Introduction to Using ANSYS FLUENT: Fluid Flow and Heat Transfer in a Mixing Elbow

provides almost all the techniques you need for setting up your case.

Vignesh V July 12, 2012 01:26

Fire Simulation using fluent
1 Attachment(s)
I think my case is different from tutorial which you are describing.

The case is not the mixing of same fluid at different temperatures and to find the heat characteristics of the mixing fluid.

My case is related to combustion and species Transport where it can be any two combustive fluid like kerosene-air, diesel-air (as mentioned in Fluent database).

I Have created a model and working on it with various B.C's. Till now I couldn't simulate a fire.

If I could simulate the profile of fire the temperature of core is same as outside temperature. If I could simulate the temperature the location of the fire is not at the exact location.

Find My model in attachments. Please help me in this case.

flotus1 July 12, 2012 02:13

So you want to simulate a combustion process?

Sorry but I misunderstood until now. I have no working knowledge about combustion modeling.

Vignesh V July 12, 2012 05:30

Fire Simulation using fluent
Thank you for your help.:)

vishnu_240 September 12, 2014 01:39

Hi, vignesh did you complete solving it? can you explain briefly if you did it?

All times are GMT -4. The time now is 07:43.