 |
 |
 |
|
|
|
[Sponsors] | ||||
July 16, 2012, 19:39
|
Mark vs Adapt for a Region
|
#1 |
|
New Member
Bradley J
Join Date: Jul 2012
Location: Cincinnati, OH
Posts: 12
Rep Power: 13  |
Hello All,
I am configuring a small circular vapor bubble in liquid water, 2D Axisymmetric. I have gone to Adapt>Region. Clicked on circle and enter my dimensions. I was told to hit Mark instead of Adapt when I was finished. I do not fully understand the difference between the two. If someone can explain it to me, I would be grateful. Thanks, Bradley |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Commercial meshers] Using starToFoam | clo | OpenFOAM Meshing & Mesh Conversion | 33 | September 26, 2012 04:04 |
| [Other] StarToFoam error | Kart | OpenFOAM Meshing & Mesh Conversion | 1 | February 4, 2010 04:38 |
| How to adapt region? | gholamghar | FLUENT | 3 | April 5, 2009 22:57 |
| different between adapt and mark region? | fadhil majnis | FLUENT | 0 | November 10, 2008 03:29 |
| [Gmsh] Import gmsh msh to Foam | adorean | OpenFOAM Meshing & Mesh Conversion | 24 | April 27, 2005 08:19 |
Linear Mode
