|August 22, 2012, 06:43||
Help needed with Fluent interfacing
Join Date: Feb 2012
Posts: 5Rep Power: 6
I am looking on the forum for some help regarding fluent .
I have generated a mesh in ansys meshing . My geometry has 2 parts- CV and a moving mesh cylinder which contains turbine blades, this cylinder has been given rotation. i have applied all BCs. When i was interfacing, fluent reads the surface of contact for CV and Moving cylinder as a wall .as a result when when i run my case the body is detecting the interface between the cylinder and CV as a wall. I guess i have some mistake in my Interfacing. I am doing it for the first time . could someone please guide me through.....?
|Thread||Thread Starter||Forum||Replies||Last Post|
|Two questions on Fluent UDF||Steven||Fluent UDF and Scheme Programming||4||September 20, 2013 16:30|
|Urgent Help Needed!!! (regarding FLUENT UDF)||dsen||FLUENT||2||May 28, 2010 13:36|
|Master node in parallel computing only distirubtion||syadgar||FLUENT||1||September 8, 2009 16:41|
|Fluent error help needed||Praveen||FLUENT||0||July 3, 2006 00:56|
|"Memory too low" problem with Fluent HELP NEEDED||Amr||FLUENT||6||May 8, 2006 12:06|