|August 23, 2012, 09:37||
Join Date: Aug 2012
Posts: 1Rep Power: 0
I am currently trying to model a multiphase flow that has to pass through a deformable porous medium and I am having issues with my dynamic mesh.
In the past, I never had troubles enabling motion for any “wall” boundaries conditions using “grid_motion” UDF. However, when I now try to move an “interior” interface between my porous zone and another fluid zone I get an "access_violation" error from FLUENT. So I was wondering if there a method in FLUENT to move the nodes of a non-solid interface between two fluid zones.
Also, is there a way to change node position for individual cells in an entire cell zone? I tried using “grid motion” but I get an access violation error when I start the simulation.
Any suggestion or help would be welcomed.
Thanks in advance.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Wind turbine simulation||Saturn||CFX||34||October 16, 2014 05:27|
|RPM in Wind Turbine||Pankaj||CFX||9||November 23, 2009 05:05|
|CFX Solver Memory Error||mike||CFX||1||March 19, 2008 08:22|
|Convective Heat Transfer - Heat Exchanger||Mark||CFX||6||November 15, 2004 16:55|
|Replace periodic by inlet-outlet pair||lego||CFX||3||November 5, 2002 21:09|