Profile(point/mesh)-Distributed load in fluent -- CFD Online Discussion Forums

September 11, 2012, 14:25

Profile(point/mesh)-Distributed load in fluent

ssixr

Member

sudhir

Join Date: Mar 2009

Location: india

Posts: 65

Rep Power: 17

hi friends,
i am trying to apply distributed/variable heat flux over a rectangular surface. i thought profile with mesh option would be best choice other than writing a udf. In fluent manual, syntax is given and i tried but not working.Problem is whenever i try to apply a mesh load, i am getting profile variables like point and even point load is also applied on surface.i will upload my profile file later as i don't have it with me..so i have attached the fluent syntax with this post....Any detail about writing a profile will be really helpful....
thank you for your time....
sudhir

Attached Images

Untitled.jpg (42.0 KB, 8 views)

Last edited by ssixr; September 11, 2012 at 14:36. Reason: addition information

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Cfd to ansys thermal to ansys structural interface	ssixr	ANSYS	17	July 31, 2015 15:18
fluent parallel problem in win7 x64 system	dunga82	FLUENT	8	April 19, 2012 20:23
What the differences flow equation of Fluent 6.3 and Fluent 12.1	opehterinar81	FLUENT	0	August 19, 2011 11:55
Fluent 6.3 32bit vs Fluent 12.0 64bit	ibex7	FLUENT	7	April 18, 2011 02:44
Fluent 12.0 is worst then Fluent 6.2	herntan	FLUENT	5	December 14, 2009 02:57

All times are GMT -4. The time now is 09:22.