|
[Sponsors] |
September 23, 2012, 13:53 |
evaporation of water vapor
|
#1 |
New Member
Milan
Join Date: Aug 2012
Location: Belgarde
Posts: 8
Rep Power: 13 |
Hi everyone!
I have the following problem: I have a 3D square channel with one of his side evaporates water vapor, how to simulate this process in Fluent. How to define the evaporation of mist air in the FLUENT? Last edited by Falcon; September 24, 2012 at 05:57. |
|
September 25, 2012, 12:55 |
|
#2 |
Senior Member
shoeb khan
Join Date: Nov 2011
Posts: 179
Rep Power: 14 |
Boiling model is in build in multiphasse eulerian model.
Just give it a try . Or use multiphase boiling mode in fluent 14.0. Hope that help. |
|
September 27, 2012, 05:17 |
|
#3 |
New Member
Milan
Join Date: Aug 2012
Location: Belgarde
Posts: 8
Rep Power: 13 |
Thanks
I'm a little wrong, but it was helpful shk12345 Last edited by Falcon; September 27, 2012 at 16:06. |
|
October 1, 2012, 11:08 |
|
#4 |
Member
Daniel Tanner
Join Date: Apr 2009
Posts: 54
Rep Power: 17 |
Unless the water is boiling then you won't need a boiling model. Water will readily evaporate without boiling. This case would only need the addition of heat and mass transfer models and is a relatively straight-forwards simulation.
|
|
October 1, 2012, 12:41 |
|
#5 |
New Member
Milan
Join Date: Aug 2012
Location: Belgarde
Posts: 8
Rep Power: 13 |
I had such a case because the process temperature was 95C, so I should just evaporate without boiling or 100C
thanks for your help |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Water Evaporation and condensation modeling | Linjie | FLUENT | 3 | February 6, 2012 14:08 |
Injection of water in vapor | SimoneTecnoil | FLUENT | 0 | November 9, 2009 12:29 |
Evaporation of water... help needed!! | Arpit | FLUENT | 2 | September 10, 2007 11:04 |
Water Evaporation and condensation modeling | Linjie | CFX | 6 | May 24, 2007 15:55 |
uptodate water distribution network | fredius,magige,tanzanian,(e.a) | Main CFD Forum | 0 | January 27, 2002 08:10 |