|
[Sponsors] |
discretization of domain by constant values in contours |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 28, 2012, 07:23 |
discretization of domain by constant values in contours
|
#1 |
New Member
Fariborz Soroush
Join Date: Oct 2009
Location: Tehran, Iran
Posts: 14
Rep Power: 16 |
Hi every one
I want to discretize my domain(a combustion chamber) by constant temperature lines and create areas. I need these areas for further analysis and need the input and output fluxes to them. I created some iso lines but when I want to report area(as a check point of area creation) I get 0 m^2!.... It's really hard for my geometry to start a new mesh{FYI I have to find many points and then change the geometry in gambit on their basis. it's really hard and time wasting...} Is there any way to discretize the domain on constant T lines?? Thanks for any suggestions. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Domain format problem on airfoil flow simulation | andrenonaka | CFX | 14 | December 7, 2015 00:42 |
ATTENTION! Reliability problems in CFX 5.7 | Joseph | CFX | 14 | April 20, 2010 15:45 |
air bubble is disappear increasing time using vof | xujjun | CFX | 9 | June 9, 2009 07:59 |
Concentric tube heat exchanger (Air-Water) | Young | CFX | 5 | October 6, 2008 23:17 |
New topic on same subject - Flow around race car | Tudor Miron | CFX | 15 | April 2, 2004 06:18 |