|September 30, 2012, 07:36||
Mass imbalance in VOF 3D modeling
Reyhaneh Sadat Ghazanfari
Join Date: Nov 2010
Posts: 10Rep Power: 5
I am running a 3D VOF model including k-e turbulence equations. The laminar solution of this model is used as the initial solution. Thus, initially, the imbalance between the two water and air inlets is zero. Unfortunately, over the course of run, the outlet mass flow is absolutely decreasing and the imbalance between inlet and outlet is increasing.
Do you have any idea?
|Thread||Thread Starter||Forum||Replies||Last Post|
|modeling wall jet with VOF||ikhajepour||FLUENT||0||May 9, 2010 12:03|
|Modeling Mass Transfer||vinaynitrkl||FLUENT||0||May 6, 2010 14:50|
|writing UDF for modelig mass transfer for VOF||ardalan soleymani||FLUENT||0||July 11, 2007 02:09|
|getting a warning about mass imbalance in reaction||lily||FLUENT||4||February 26, 2006 09:37|
|VOF model with the mass transfer?||ROOZBEH||FLUENT||0||April 21, 2003 05:23|