|October 10, 2012, 15:05||
Help Needed for FLUENT setup in removal efficiency
Join Date: Oct 2012
Posts: 1Rep Power: 0
I am new to FLUENT, but my project requires using it to demonstrate a CFD on removal efficiency on a model.
The model is inside a pipe, and first create a vortex, then using baffles to remove some of the particulates in the gas stream.
I could mesh my model, but I have difficulties in setting it up.
The particulates are metal oxides, and about 20% wt in the stream, the stream is just air. Pressure drop through the pipe is less than 1 psi. Length of pipe 8ft.
Your answers are highly appreciated.
|Thread||Thread Starter||Forum||Replies||Last Post|
|[ICEM] Hexa mesh, curve mesh setup, bunching law||Anorky||ANSYS Meshing & Geometry||4||November 12, 2014 01:27|
|compiling firefoam||Farshad_Noravesh||OpenFOAM||27||December 24, 2012 05:21|
|Help needed to setup CD nozzle exhausting to atmosphere||sangrampp||FLUENT||10||January 27, 2011 12:06|
|mentor needed||doctsh||FLOW-3D||7||August 10, 2010 03:16|