|
[Sponsors] |
Help Needed for FLUENT setup in removal efficiency |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 10, 2012, 15:05 |
Help Needed for FLUENT setup in removal efficiency
|
#1 |
New Member
jlvnb
Join Date: Oct 2012
Posts: 1
Rep Power: 0 |
Hi guys,
I am new to FLUENT, but my project requires using it to demonstrate a CFD on removal efficiency on a model. The model is inside a pipe, and first create a vortex, then using baffles to remove some of the particulates in the gas stream. I could mesh my model, but I have difficulties in setting it up. The particulates are metal oxides, and about 20% wt in the stream, the stream is just air. Pressure drop through the pipe is less than 1 psi. Length of pipe 8ft. Your answers are highly appreciated. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Hexa mesh, curve mesh setup, bunching law | Anorky | ANSYS Meshing & Geometry | 4 | November 12, 2014 00:27 |
compiling firefoam | Farshad_Noravesh | OpenFOAM | 27 | December 24, 2012 04:21 |
Help needed to setup CD nozzle exhausting to atmosphere | sangrampp | FLUENT | 10 | January 27, 2011 11:06 |
mentor needed | doctsh | FLOW-3D | 7 | August 10, 2010 03:16 |