 |
 |
 |
|
|
|
[Sponsors] | ||||
November 4, 2012, 16:07
|
Air to Air Heat Exchanger
|
#1 |
|
New Member
Siddharth
Join Date: Nov 2012
Posts: 8
Rep Power: 13  |
Hi guys im new to using Fluent and am simulating the heat transfer in a heat exchanger where both the medium are air...
The cold air flows through a single tube and the hot air flows through the bottom face as marked in the figure. the air travels up flows around the baffle and goes down and exits as marked in the figure. I have the inlet temperature of cold air and hot air and also the volumetric flow rates. Please could any one let me know how to simulate this model in fluent? Do i need to use a heat exchanger model or can it be done just by plain simulation. I have attached a picture of the model. Any help is appreciated. |
|
|
|
|
|
November 4, 2012, 16:17
|
|
#2 |
|
New Member
Siddharth
Join Date: Nov 2012
Posts: 8
Rep Power: 13 |
this is the image of the model in 2d...the image has to be modelled in 3d....
|
|
|
|
|
|
|
November 10, 2012, 13:34
|
|
#3 |
|
New Member
Siddharth
Join Date: Nov 2012
Posts: 8
Rep Power: 13 |
@[-mAx-]
can u tell me how to create the geometry in gambit? |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Heat Exchanger Model | sak2129 | FLUENT | 3 | September 26, 2017 01:29 |
| UDF for Heat Exchanger model | francois louw | FLUENT | 2 | July 16, 2010 02:21 |
| Heat Exchanger Simulation | tightaznbreaka | FLUENT | 0 | March 18, 2010 15:45 |
| air bubble is disappear increasing time using vof | xujjun | CFX | 9 | June 9, 2009 07:59 |
| Heat exchanger | mkiku | FLUENT | 1 | July 21, 2004 09:53 |
Linear Mode
