|November 20, 2012, 14:15||
repeat geometry simulation
Join Date: Nov 2012
Posts: 1Rep Power: 0
Hi Guys, firstly this is my first time using this forum so my apologies if this is the wrong section.
i am currently using ansys workbench 14 for some CFD, using fluent.
i am running simulations of coolant through radiator tubes, i have the tube modeled, meshed and managed got the results i was looking for for the single tube, my query is whether it is possible to tell ansys to run a simulation with say 30 of these tubes orientated as they would be in a radiator so each inlet inline with around 10mm gap in the z asix.
sorry if that is a bit confusing, i hope somebody can help,
|Thread||Thread Starter||Forum||Replies||Last Post|
|[ICEM] Generating Mesh for STL Car in Windtunnel Simulation||tommymoose||ANSYS Meshing & Geometry||48||April 15, 2013 04:24|
|Fan simulation divergence||ayothicfd||CFX||18||July 20, 2012 05:53|
|[ICEM] O-grid around wing geometry||Anorky||ANSYS Meshing & Geometry||12||August 17, 2011 21:28|
|Export geometry in workbench from simulation.||kezman||ANSYS Meshing & Geometry||1||October 14, 2009 14:06|
|Simulate geometry in different parts||Ralf Schmidt||FLUENT||0||July 29, 2005 10:08|