|December 4, 2012, 14:21||
Reverse Flow Issues for Pulverised Coal Injection
Join Date: Dec 2012
Posts: 3Rep Power: 4
I am analysing a pulverised coal injection process and every time I run my model I am having severe reverse flow issues on numerous faces of the pressure outlet along with a solution that does not converge properly.
I have tried refining the mesh and also ensuring the inlet conditions are correct and have a significantly higher pressure than the outlet but still no luck.
Any suggestions would be much appreciated.
|convergence fluent, reverse flow|
|Thread||Thread Starter||Forum||Replies||Last Post|
|reverse flow in pressure outlet||Thomas Getza||FLUENT||14||August 5, 2015 10:42|
|Coal combustion injection properties||semo||FLUENT||10||May 2, 2014 11:03|
|On and Off of Reverse flow warning||prince_pahariaa||FLUENT||1||December 24, 2011 06:22|
|reverse flow at outlet||Neil||FLUENT||1||June 22, 2005 00:49|
|About injection flow||roof||FLUENT||1||August 19, 2003 03:00|