euler-euler for wind blown sand flow
 

hi bros,

I adopt euler-euler model to simulate wind blown sand flow. The primary phase is wind flow and the second phase is sand. Air blow into the tunnel to get the sand particles "started", which are included in the case file.

Some questions are listed as follows

1 in the "cell zone conditions" tab, how to assign the two different phases? Could they be assigned different phase separately or only set as mixture?

2 in the "boundary conditions" tab, how to assign the two parts as different phases?

3 in the "boundary conditions" tab, which type of boundary condition fit for the interface of the "sand" and "air"?

Thank u guys~~

here is the case link. virus free

http://www.sendspace.com/file/21ukjq

Hi,

I doing some thing similar to your work but water sand ... can we cooperate for beter results? i need some one to discuss with about my issue and sure you need also.
my email is ausama_ali27@yahoo.com

Your file is not openable.

This message appaers
"Warning: An error or interrupt occurred while reading the journal file.
Some commands may not have been completed."