Eulerian model

nabaen · December 20, 2012, 22:35

Hi
I am modeling a cyclone. Unfortunately it does not converge with DPM model Therefore I decided to apply Eulerian model instead of DPM .Now there is some question:
1-Can I use RSM model and Eulerian model together?
2-How can i define a range of diameters of solid in Eulerian model?Is it possible?
Thanks in advanced.

Al-Hashimi · December 21, 2012, 01:42

Hi, I'm doing the same simulation on Hydrocyclone, so we may can assist each other’s.
I read some papers talking about simulating the cyclone with Mixture, Eularean and DPM.

Please read my thread here, you may have a solution to my problem

Fluent velocity magnitude contours

msaeedsadeghi · December 21, 2012, 02:28

Hi.
Good cooperation. Hope success in your project together

December 20, 2012, 22:35	Eulerian model	#1
nabaen New Member Join Date: Dec 2012 Posts: 13 Rep Power: 2	Hi I am modeling a cyclone. Unfortunately it does not converge with DPM model Therefore I decided to apply Eulerian model instead of DPM .Now there is some question: 1-Can I use RSM model and Eulerian model together? 2-How can i define a range of diameters of solid in Eulerian model?Is it possible? Thanks in advanced.

December 21, 2012, 02:28		#3
msaeedsadeghi Senior Member Saeed Sadeghi Join Date: Oct 2012 Location: Iran Posts: 217 Rep Power: 3	Hi. Good cooperation. Hope success in your project together __________________ Regards, Saeed Sadeghi Ansys Fluent CFD Consultant

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Superlinear speedup in OpenFOAM 13	msrinath80	OpenFOAM Running, Solving & CFD	17	August 22, 2009 03:59
question about eulerian model for packed bed	rone	FLUENT	2	July 19, 2007 20:58
Mass and het transfer using eulerian model	Pablo	FLUENT	0	February 16, 2007 08:36
the Eulerian model and the lower volume fraction	hx li	FLUENT	2	October 27, 2005 06:17
Strain Rate in eulerian model	galeazzo	FLUENT	0	January 25, 2005 07:52

December 21, 2012, 01:42		#2
Al-Hashimi Member Osamah Ali Al-Hashimi Join Date: Jul 2012 Posts: 41 Rep Power: 2	Hi, I'm doing the same simulation on Hydrocyclone, so we may can assist each other’s. I read some papers talking about simulating the cyclone with Mixture, Eularean and DPM. Please read my thread here, you may have a solution to my problem Fluent velocity magnitude contours