.dat file in fluent
when i call my .dat file in fluent i notice this...
Quote:
i have converted my openfoam data to fluent .dat case....on viewing with fluent display->contour->velcity. i found the whole domain red in colour 2- why does i have a lot of .dat files? Am i not supposed to have found only 1? i would be really grateful to anyone who answer my queries regards zaynah |
It seems an error in dimensions... Is your model 2D or 3D? Did you open Fluent for the same dimensions than your model?
|
yes i did..:(
model is 2D |
Hi? I am now facing the similar problem. It's not about the dimensions, but sth else. It sometimes works, while sometimes not. It's about the number of residuals counted. very confusing.
|
Quote:
Dear zaynah i have tried the same thing but didn't suceeded. You may try to post process the result in tecplot,ensight,paraview. You may be to work a little more in these software but that will work out. For loading the data file load the last data file in it. Hope this helps shk |
I met the same problem and found that was because that I tried to use Fluent V14 to open a V14.5 data file. The data file can be read by using 14.5 or probably a more higher version.
|
Quote:
have you tried to check whether this warning would have effects on the final results? thanks very much. |
All times are GMT -4. The time now is 18:25. |