About layering in dynamic mesh

MapleGuy · January 9, 2013, 12:22

Hi, I'm solving a gas-solid problem using Fluent. If you can see the attached graphic, the boundary 0-0 is movable, but the faces on this boundary, that is, ab, bc, cd, etc, have different displacement in each time step. In this case, can I use layering as the method of re-mesh? If yes, which macro should I use to define the movement of the faces, DEFINE_CG_MOTION, DEFINE_GRID_MOTION or DEFINE_GEOM?

MapleGuy · January 9, 2013, 12:24

Is there any body can help me? Thank you all in advanced.

MapleGuy · January 11, 2013, 16:17

I tried it myself. The answer is yes, but the qualify is not satisfying. The cell layer will merge or split when any node on this layer meet the requirement we set.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Is my Dynamic mesh setup correct?	cfd seeker	FLUENT	16	October 30, 2020 06:16
Dynamic mesh is not getting updated.	cardio	FLUENT	1	May 20, 2014 08:41
potentialFreeSurfaceFoam with Dynamic Mesh	GuilhermeMP	OpenFOAM Programming & Development	1	October 6, 2013 03:05
3D Hybrid Mesh Errors	DarrenC	ANSYS Meshing & Geometry	11	August 5, 2013 06:42
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere!	sc298	OpenFOAM Meshing & Mesh Conversion	2	March 27, 2011 21:11

January 9, 2013, 12:24		#2
MapleGuy New Member Gordon Join Date: Jan 2013 Posts: 3 Rep Power: 13	Is there any body can help me? Thank you all in advanced.

January 11, 2013, 16:17		#3
MapleGuy New Member Gordon Join Date: Jan 2013 Posts: 3 Rep Power: 13	I tried it myself. The answer is yes, but the qualify is not satisfying. The cell layer will merge or split when any node on this layer meet the requirement we set.