|
[Sponsors] |
January 12, 2013, 07:56 |
Heat transfer problems
|
#1 |
New Member
nagarajan
Join Date: Jul 2012
Posts: 7
Rep Power: 13 |
There is a problem I frequently facing when I solve heat transfer problems
when I solve a CHT(Conjugate heat transfer) problem with heat source fluent says"temperature limited to 5000 " and temperature plots has values less than 273 (minimum range).Is it an error? how to over come this?pl help me.... nag |
|
January 13, 2013, 10:59 |
|
#2 |
Senior Member
SSL
Join Date: Oct 2012
Posts: 226
Rep Power: 14 |
So many things can cause this problem. Care of the boundary conditions.
|
|
January 13, 2013, 11:31 |
|
#3 |
Senior Member
Join Date: Mar 2011
Location: Germany
Posts: 552
Rep Power: 20 |
There could be three causes for this problem.
1. Some quality cells in the mesh 2. Improper initial conditions 3. Problem in boundary conditions |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Heat transfer (conduction) between two pipes | shields | FLUENT | 14 | February 3, 2016 08:45 |
Heat Flux at wall in a conjugate heat transfer problem | Chander | CFX | 2 | July 9, 2011 23:22 |
MRF and Heat transfer calculation | Susan YU | FLUENT | 0 | June 2, 2010 09:46 |
How can I increase Heat Transfer at Domain Interf? | B.Simon | CFX | 3 | October 28, 2008 19:53 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 16:55 |