|
[Sponsors] |
January 16, 2013, 06:18 |
How to read out results on the cover
|
#1 |
New Member
Join Date: Dec 2012
Posts: 10
Rep Power: 13 |
Hey,
I have simulated a waterflow through a pipe and now I am interested in the numerical results of the surface heat transfer coefficient on the cover. Therefore I set Points (Surface-> Points) near the cover. When I now simulate the Flow all the results are zero (that is wrong, as I can see the graphics). Please help me and tell me how I get the results on specific Points on the cover without just read it out by holding my mouse on it. Thank you=) |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem: Very long "write" time (~2h-3h) for results and transient results | Shawn_A | CFX | 16 | April 12, 2016 20:49 |
Transient Run - Output "Time" in partial results? | evcelica | CFX | 2 | May 16, 2012 21:36 |
Lost Scenario Results..?? | Fugacity | Autodesk Simulation CFD | 1 | February 24, 2012 10:48 |
How can I read the results? | samiam1000 | OpenFOAM | 11 | November 15, 2011 06:07 |
Phase locked average in run time | panara | OpenFOAM | 2 | February 20, 2008 14:37 |