|
[Sponsors] |
February 15, 2013, 04:22 |
SAS Confusion
|
#1 |
Senior Member
Philipp
Join Date: Jun 2011
Location: Germany
Posts: 1,297
Rep Power: 26 |
Dear experts,
I am once again confused. Look at the two pictures: Fluent 13.0 FLU.jpg Fluent 14.5 FLU2.jpg It's a flow over a bluff body, flow enters on the left (velocity inlet) and leaves on the right (pressure outlet). Front and back are symmetry planes, top and bottom are periodic. Pictures show iso surfaces of Turb. Kin. Energy. Both flows use the same grid, the same initialization, settings and so on. SAS turbulence model! (14.5 looks like URANS) Did they change anything from 13.0 to 14.5 that could cause such a difference?
__________________
The skeleton ran out of shampoo in the shower. Last edited by RodriguezFatz; February 15, 2013 at 04:52. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
SAS Turbulence model in OpenFOAM | Steven85 | OpenFOAM | 0 | July 22, 2011 05:36 |
ICED AIRFOIL and SAS model | Typhoon | CFX | 0 | April 8, 2011 19:09 |
SAS model | lakeat | OpenFOAM Running, Solving & CFD | 1 | August 28, 2009 03:26 |
SAS model | Itsme | Main CFD Forum | 0 | October 24, 2008 11:34 |
SAS Model | Manu | CFX | 8 | September 15, 2006 17:59 |