 |
 |
 |
|
|
|
[Sponsors] | ||||
February 15, 2013, 08:02
|
How to merge passages?
|
#1 |
|
New Member
Marek
Join Date: Feb 2013
Posts: 3
Rep Power: 2  |
Hello everyone,
I'd like to make a CFD simulation of pump impeller in fluent. I made mesh in the TurboGrid v13. The problem is that impeller will be connected with the volute so I need full impeller mesh not only 1 passage (6 blades=6passages). How can I get full mesh? I've tried use merge in fluent I merged zones but I don't know how I should connect them in 1 mesh and don't have interface between passages. Now I have wall between passages. How can I delete that face and get 1 mesh of whole impeller in fluent? Should I use other programs (eg. ICEM)? Best wishes, Marek |
|
|
|
|
 |
| Tags |
| fluent, impeller, merge mesh |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Problem when I try to merge hexa & prism | pipolaki | ANSYS Meshing & Geometry | 7 | December 4, 2012 08:44 |
| [ICEM] Merge mesh - non manifold vertices | BrolY | ANSYS Meshing & Geometry | 4 | October 30, 2010 22:07 |
| assemble the mesh | feixiangniao | ANSYS Meshing & Geometry | 2 | March 20, 2010 03:39 |
| about merge mesh | lian | Main CFD Forum | 3 | February 29, 2008 10:47 |
| bolt air passages design | Eric JAOUEN | Main CFD Forum | 0 | July 25, 2003 08:47 |
Linear Mode
