|March 1, 2013, 13:35||
Turbine and Dynamic mesh
Join Date: Apr 2011
Posts: 23Rep Power: 6
I am working on piston turbine (2D) which is similar to gear pump. The gears are replaced by two pistons which rotates in opposite directions at 500 rpm.
I need to obtain flow field inside turbine. Because the region around pistons is deforming I used dynamic mesh for deforming surface. I wrote UDF for rotation moving of pistons. For deforming region I generated mesh using triangles which have size of 1 mm. The inlet pipe and outlet pipe are meshed using quads, size 5 mm. When I start to preview mesh motion after about 8 time steps I have skewness above 0.9. My step size is 1e-5. I have setup smooting and remeshing options and used default values.
I have attached some pictures.
Can anyone help me.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Difficulty in calculating angular velocity of Savonius turbine simulation||alfaruk||CFX||8||December 3, 2013 17:51|
|radial turbine blade simulation with dynamic mesh 6dof(fluent)||mamyjooooon||FLUENT||0||April 7, 2011 14:28|
|Wind turbine simulation with dynamic mesh.||sushil||FLUENT||7||October 28, 2008 01:40|
|Dynamic mesh analysis||Hussein||FLUENT||0||February 19, 2007 09:03|
|Dynamic mesh with turbomachinery||Emanuele||FLUENT||0||September 7, 2005 09:30|