 |
 |
 |
|
|
|
[Sponsors] | ||||
DPM massflow calculation using diameter and velocity |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 25, 2013, 08:55
|
DPM massflow calculation using diameter and velocity
|
#1 |
|
New Member
Join Date: Mar 2013
Posts: 2
Rep Power: 0  |
Because I am using laser PDA measurements, I try to calculate the particles massflows using particles diameter and velocity. Is it possible ?
|
|
|
|
|
|
March 26, 2013, 03:22
|
|
#2 |
|
Member
Thiagu
Join Date: Oct 2012
Location: India
Posts: 60
Rep Power: 13 |
You can calculate based on SMD, del P,Area and viscosity. there is a specific expression in the book " Atomization and spray" - Hentry Lefebvre.
|
|
|
|
|
|
|
March 26, 2013, 06:09
|
|
#3 |
|
Senior Member
OJ
Join Date: Apr 2012
Location: United Kindom
Posts: 473
Rep Power: 20 |
Be careful here, since SMD (Sauter Mean Diameter) is a statistical representative of the diameters of particles here and not a mean diameter. Unless all your particles are same, the mean diameter and sauter mean diameter will be different.
OJ |
|
|
|
|
|
|
March 26, 2013, 09:49
|
|
#4 |
|
New Member
Join Date: Mar 2013
Posts: 2
Rep Power: 0 |
OK, thanks to all.
|
|
|
|
|
|
|
December 26, 2013, 02:15
|
|
#5 |
|
New Member
Rodman
Join Date: Dec 2013
Posts: 7
Rep Power: 12 |
Why not use P_FLOW_RATE(p)?
|
|
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Difficulty in calculating angular velocity of Savonius turbine simulation | alfaruk | CFX | 14 | March 17, 2017 06:08 |
| Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |
| Steady pipe flow mean velocity higher than inlet velocity | anita | OpenFOAM Running, Solving & CFD | 7 | September 25, 2012 05:35 |
| Velocity profiles problem behind the elbow (3D problem) | kabat73 | FLUENT | 8 | May 9, 2010 04:26 |
| velocity more than INLET velocity | neu | FLUENT | 3 | May 13, 2003 04:56 |
Linear Mode
