|
[Sponsors] |
March 28, 2013, 18:25 |
Double Tube Flow
|
#1 |
New Member
Join Date: Jul 2009
Posts: 13
Rep Power: 16 |
hi;
i want to solve a natural convection in a double tube. water flows thorough the innert tube, and there is air in the annuli (and there is a natural convetion there). i can not set up the problem because there is an interface between two tubes. i send a figure in attachment about geometry and boundary conditions. if i select interface boundary condition for "interface" fluent says "WARNING: mesh check failed. "To get more detailed information about the mesh check failure increase the mesh check verbosity via the TUI command /mesh/check-verbosity. " if i select wall boundary condition for "interface" then fluent creats a interface-shadow. i select coubled under "thermal conditions" then define other boundary conditons. when i came the initialize section there is already "-1.#IND" in the velocity inlet and all zones. i delete that and put actual values. but fluent could not solve the problem, say "divergence detected in AMG solver: x-momentum" what can i do, how can i solve this problem i defined. thanks already sorry for poor english |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
problem in toposet | Ahmed Khattab | OpenFOAM Pre-Processing | 27 | March 3, 2023 22:12 |
Outlet boundary condition for a heated tube flow | JinBiao | OpenFOAM Running, Solving & CFD | 0 | July 28, 2012 04:56 |
concentric/tube in tube counter flow HX | ask123 | FLUENT | 0 | May 24, 2010 07:41 |
Flow Through Bend tube of circular c/s | applemango | FLUENT | 0 | March 8, 2010 05:52 |
Can 'shock waves' occur in viscous fluid flows? | diaw | Main CFD Forum | 104 | February 16, 2006 06:44 |